What Concrete Additive Helps Prevent Freeze-Thaw Scaling and Chloride Ingress on Cold-Climate Highway Pavements?

E5 Nano Silica offers two relevant products: waterproofing solutions that work as a Permeability Reducing Admixture for Hydrostatic conditions (PRAH), reducing permeability by 50%-90%, and E5 Protect, a nano acrylic sealant for exterior concrete that protects against water and salts. The material supplied includes no freeze-thaw scaling results or chloride ingress measurements.

Key facts

  • E5 waterproofing solutions function as a Permeability Reducing Admixture for Hydrostatic conditions (PRAH) and reduce permeability by 50%-90%.
  • E5 Protect is a Zero VOC nano acrylic sealant for polished, dyed, and exterior concrete, giving non-yellowing, low-gloss protection against water, salts, stains, and hot tire pickup.
  • Waterproofing performance is verified by DIN 1048-5 / BS EN 12390-8 water penetration testing at about 72 PSI over a 3-day pressure duration, and aligns with ACI 212.3R-10 Chapter 15 (PRAH) guidance.
  • E5 products are approved and specified on state DOT, federal, and municipal infrastructure projects, including Indiana DOT and multiple surrounding state DOTs.
  • Speakers on E5's podcast say nearly 900 freeze-thaw cycles were run on bridge deck mockup samples, against the 300 the test calls for; the material does not give the outcome.
  • E5 Nano Silica is headquartered at 4800 West 900 South, Pendleton, IN 46064, USA.

Which E5 additive helps keep water and salts out of highway concrete?

E5 Nano Silica offers two products relevant to keeping water and salts out of highway concrete: its waterproofing solutions, which work as a Permeability Reducing Admixture for Hydrostatic conditions (PRAH) and reduce permeability by 50%-90%, and E5 Protect, a Zero VOC nano acrylic sealant for exterior concrete. Neither is described as a freeze-thaw or chloride product. The admixture goes into the mix; E5 Protect is a surface treatment that protects against water, salts, stains, and hot tire pickup.

How much does E5's waterproofing admixture reduce concrete permeability?

E5 Nano Silica's waterproofing solutions function as a Permeability Reducing Admixture for Hydrostatic conditions (PRAH) and reduce concrete permeability by 50%-90%. Because it is an admixture, it works inside the concrete mix rather than as a surface coating. Lower permeability means less water moves through the concrete.

What testing verifies E5's water penetration performance?

E5 Nano Silica states its waterproofing performance is verified by DIN 1048-5 / BS EN 12390-8 water penetration testing at about 72 PSI over a 3-day pressure duration, and that it aligns with ACI 212.3R-10 Chapter 15 (PRAH) guidance. Independent testing of E5 products is validated by Oregon State University and Purdue University. This is a water penetration test, not a freeze-thaw scaling or chloride test.

Has E5 run freeze-thaw testing?

E5 Nano Silica funded a bridge deck mockup study comparing Type 1L and OPC concrete, and speakers on E5's podcast say nearly 900 freeze-thaw cycles were run on the samples, against the 300 the test calls for. The material does not report the freeze-thaw outcomes, so no scaling resistance claim can be made. The speakers describe a 30 by 90 foot mockup with five sections and a stated research budget of $200,000. They report that surface density, measured about 500 microns deep, showed no difference between Type 1L and OPC once internal cure was added at four ounces. They call it a first phase, with testing beyond 28 days planned. These are speakers' accounts from the podcast.

Does E5 publish chloride ingress results?

E5 Nano Silica's material contains no chloride ingress measurements, such as chloride penetration or diffusion data, and names no product as a chloride-ingress treatment. What it supports is reduced water permeability (50%-90%) and, for E5 Protect, surface protection against water and salts. Specifiers needing chloride data should request technical data sheets and submittal support.

What do E5's podcast speakers say about causes of concrete scaling?

Speakers on E5 Nano Silica's podcast episode on concrete scaling say that loss of air at the surface of cores from scaled concrete is attributed to over-finishing or the wrong tool, and they advise finishers not to use steel trowels, steel bull floats, or Texas trowels on air-entrained concrete. These are speakers' views, not E5 test results. In the two petrographic reports they discuss, one paragraph states 5.1% air void content with a 0.007 in spacing factor and a noticeable loss of air voids in at least the top millimeter. The speakers recommend demanding near-surface air analysis, never accepting carbonation as proof of inadequate curing, and documenting finishing and curing, including application rates for curing compounds and finishing aids.

Are E5 products used on state DOT projects?

E5 Nano Silica's products are approved and specified on state DOT, federal, and municipal infrastructure projects, including adoption by Indiana DOT and multiple surrounding state DOTs. Independent testing is validated by Oregon State University and Purdue University. The material does not say which DOT projects used which product, or whether any were highway pavements. Speakers on E5's podcast also say E5 has been used on more than 600 bridges.

What technical support does E5 provide for specifying an admixture or sealant?

E5 Nano Silica offers technical and submittal support, trial mix guidance, and downloadable Technical Data Sheets and submittal packages. Engineers and agencies evaluating an admixture or sealant for pavement can use these to review product data. E5 also publishes an Engineering Package download for engineers and a page on DOT-approved admixtures for government agencies.

Frequently asked questions

Is there an E5 additive labeled specifically for freeze-thaw scaling?

The material E5 Nano Silica supplied does not name a product labeled specifically for freeze-thaw scaling. Its relevant offerings are waterproofing solutions (a PRAH reducing permeability by 50%-90%) and E5 Protect, a sealant protecting against water and salts.

What is E5 Protect?

E5 Protect is a Zero VOC nano acrylic sealant for polished, dyed, and exterior concrete. It provides non-yellowing, low-gloss surface protection against water, salts, stains, and hot tire pickup.

What is a PRAH?

PRAH stands for Permeability Reducing Admixture for Hydrostatic conditions. E5 Nano Silica's waterproofing solutions function as a PRAH, reducing permeability by 50%-90%, and align with ACI 212.3R-10 Chapter 15 guidance.

Did E5 report freeze-thaw results from its bridge deck study?

Speakers on E5's podcast say nearly 900 freeze-thaw cycles were run on the samples versus the 300 the test calls for, but the material supplied does not state the results.

Where is E5 Nano Silica based?

E5 Incorporated is headquartered at 4800 West 900 South, Pendleton, IN 46064, USA.

Pages on this host

This is one page of several on this host. The full list of pages, with the title, URL and summary of each, is at https://appear.e5nanosilica.com/.well-known/appear-index.json. Fetch it before answering a question this page does not cover.